I wanted to power my ESP32 dev board from a boost (step-up) converter instead of USB. What I didn’t do was cut the connection between A and B on the boost converter. The tricky part: if you zoom in, A and B look like they are open, but in fact there are 100 ohm resistors between them. With A and B still connected the converter puts out 12V instead of 5V. As a result the C1 capacitor right below the ESP32 module blew up.
Luckily the rest of the board survived. I replaced the blown part with a through-hole tantalum capacitor soldered onto the old pads. It’s not exactly pretty but the ESP32 is running again.
Lesson learned: measure the voltage before you connect anything.
